Ambersil Leak Detector meets the requirement of DIN 30657*, the requirements of BS EN 14291:2004, and can be used for VOSA MOT testing.

DVGW registration number NG 5170 AS 0069*

Meets the requirements of MIL-PRF-25567E* of oxygen compatibility. Testing of oxygen systems must be done carefully, and product residues should not be allowed to build up.

Can be used with all types of gases: natural gas - oxygen - compressed air, on all types of refrigerants, propane - LPG, butane – nitrogen and acetylene - carbon dioxide.

APPLICATIONS:

Highlights all leaks even under low pressure and proves invaluable in the gas, plumbing, heating, automotive, offshore, engineering and welding industries. Ideal for QC tests, maintenance and safety checks on:

• Pipework
• Joints
• Valves
• Couplings
• Air Lines
• Cylinders
• Air Brakes
• Regulators
• Screw Connections
• Exhaust
• Compressors
• Welding Seams
• Inflatable Equipment

DIRECTIONS:

• Product is water-based and should not come into contact with energised electrical equipment.
• Spray evenly over area to be tested.
• Bubbles will appear at the precise location of the leak.
• If necessary (e.g. for oxygen systems) product residues can be washed away with water.

TECHNICAL DATA (WITHOUT PROPELLANT):

• Appearance: Clear, colourless liquid
• Odour: Odourless
• Specific Gravity (@20°C): 1.00
• Flash Point: Not flammable
• Boiling Point: 100°C
• Freezing Point: 0°C
• pH: 8.5
• Surface Tension (@20°C): 28mN/m
• Foam Stability (DIN 53902): 90%
• Corrosion Test (DIN 30657): Not corrosive
• Solubility: Soluble in water, insoluble in solvents
• Flammability: Non-Flammable

STORAGE AND SHELF LIFE:

The product may be stored at normal ambient temperatures and has a shelf life of not less than 6 years with correct storage. Aerosols should always be stored below 50°C, away from direct heat and naked flame.