The AV-30-C has an FAA STC with EASA and CAA Approval.

Cutting-Edge Technology Without the Cutting

AV-30 fits in your existing 3” panel slot seamlessly. By mounting from behind, it preserves the “round dial” look, and eliminates the need for cutting or replacing your panel.

Avoid Stalls

The AV-30 alerts you visually and aurally if you approach a dangerous AoA. This is calculated by comparing the aircraft’s pitch, flight path and G-loading.  

14 in 1 customisable functional display:

• Primary Attitude
• Primary Slip
• Primary Direction Indication
• Probeless Angle of Attack
• Indicated Airspeed (KTS/ MPH)
• Altitude/ Vertical Trend / Alerter
• +8 / -8 G-Meter
• OAT/ TAS/ Density Altitude
• Bus Voltage
• GPS Navigation Data Overlay
• GPS HIS/ 360 ROSE/ Arc Map Mode
• Customisable Colours, Fonts & Layouts
• Audio Alerts (AoA, G, Roll Limits)

Transponder Control

Travel beyond borders with tailBeaconX, the globally accepted, Aireon enabled, 1090/ES ADS-B Transponder. The AV-30 paired with the tailBeaconX allows you to easily set your mode and squawk while enabling the additional functionalities of the AV-30.

Live Traffic on AV-30

Plug-in the AV-Link to your AV-30 serial port, connect the AV-link to your ADS-B receiver via Wi-Fi. This works perfectly with a SkyEcho 2 (Click Here).

What is required for an AV-30-C installation?

The AV-30 holds an STC-PMA with AML. The installation must be performed by a licenced aircraft technician and the appropriate paperwork must be submitted as part of the instillation. This unit is shipped with the AV-30, DB-15 connector, DB crimps, and a backshell for the DB connector. The DB-15 connector needs to be populated with pins based on the functions desired for the specific installation. If the aircraft is IFR certified the pitot/ static systems will need to be tested and certified after the AV-30 is added to the system.

TECHNICAL SPECIFICATIONS
Input Voltage Nominal: +10 to +32 VDC
Input Voltage Max: +60 VDC
Input Power Nominal: 6 Watts (0.5 Amps @ 12VDC)
Input Power Max: 12 Watts (1.0 Amps @ 12VDC)
Required Circuit Breaker: 2 Amp
Operation on Battery: 2 Hours Typ @ 20°C / 30 Minutes Min @ -20°C

PHYSICAL ATTRIBUTES
Mounting Configuration: 3 1/8″ Round Instrument Hole
Dimensions wo/Connector: 3.38 x 3.38 x 1.6 Inches
Weight: 0.50 Lbs.
Electrical Connector: 15 Pin Male D-Sub
Pneumatic Connectors: ¼” OD Quick Connect
Mounting: (4X) #6-32 Machine Screws
Case Material: Billet Aluminium

ENVIRONMENTAL
Operating Temp: -20°C to +55°C
Storage Temp (48 Hrs): -30°C to +80°C
Humidity(48 Hrs): 90% RH

DISPLAY
Diagonal Size: 3″ Circular
Contrast Ratio (Typical): 500
Brightness (Typical): 1000 cd/m2
Viewing Angle Left/ Right: 60°
Viewing Angle Up: 45°
Viewing Angle Down: 10°
Backlight Lifetime (Typical): 50,000 Hrs

Excludes the pre-wired harness with 15 Pin D-Sub connector.